The COVID finally got me

****UPDATED 2026****

 

There's new spike protein mutations doing the rounds out there, be careful people 

 

From 2022:

 

Two and a quarter years in, Corona Virus finally got me.


I got a message from someone I'd spent 30 minutes in fairly close proximity with, two days after the fact they felt a 'bit off' and tested positive, they suggested I might want to test.

 

So, I did. 

 

And yeah, wow, that red line appeared almost instantly and just got darker the longer I left it.

 

Cue a few days of feeling pretty crappy, sore throat, breathless, headachey and I've been vaccinated so I only got a mild case.

 

After effects, it ruined my taste buds, even the smell of coffee makes me heave now and even weeks after,  I can't taste properly, far worse than when I was a smoker.

 


Comments

Post a Comment

Popular posts from this blog

3D printing the things.

Image
I bought a very cheap Yaesu VX1-R dual band handy last year, it's a cute little thing that covers 2 and 70 but unfortunately it came without the battery. No problem, if it works I'll just buy a replacement, simple. But WOW, the FNB-52 battery is *expensive*, more than three times what I paid for the radio and I could not find one in stock anywhere (I have since found them)... I did find out that the battery pack is a standard 14650 Li-Ion cell in a molded plastic case (presumably including a battery management circuit) and a quick search of everyone's favourite tat bazaar eBay found a pack of two for a not expensive £9 so I ordered some and waited. When they arrived I gave them a few hours on charge and then tried one in the handy, it worked but of course it rattles about and runs the risk of being damaged or, worse, exploding if charged incorrectly as the cell isn't 'protected'. Now I do have a charger but it meant I'd have to remove th...
Read more

MiniPA 70 build, almost there.

Image
A quick update, I needed a heatsink so I found one from an old PC which is more than adequate, weighing in at almost 650 grammes I reckon it should be able to handle the heat. Problem though, it's not flat. Which makes it kind of difficult to mount the board. Now, I could use some standoffs, PCB pillars cut to length but I'm a little light on machine tools to make an accurate job of it and it'd annoy me that it was 'wobbly'. As it happens, I recently bought myself a new toy. A Flashforge 3D printer so this seemed an ideal opportunity to learn to use a CAD program and find out how dimensionally accurate the printer is. It turns out, it's pretty good. And the PLA takes a thread really nicely. So, my Mini PA board now has mounts, I just need to drill and tap some holes in the heatsink.
Read more

MiNi PA eBay 70 W MOSFET amplifier

Image
We've all seen switching FETs used as PA devices in HF radios, I've experimented with them a few times, lashing up circuits using IRF520s and, my favourite, the FQP13N10, they can produce some useful power for such a cheap device and if you drive them hard, they give some serious power, at 24 volts, with a shade over 3 watts drive I've measured 45 watts output at 30MHz from a single device into a dummy load (you really don't want to put one on the air like that though, the output was horrible) When you drive them hard, they're fragile, gouts of smoke, chunks of epoxy encapsulation flying across the room and dead fuses are easy to obtain so, I gave up, 'proper' RF devices aren't that much more expensive and are designed for use in radios. So, why am I talking about them again? Well, I bought myself one of the Chinese eBay specials, a Mini PA 70W HF amplifier that uses a pair of IRF520* devices to produce a reputed 70 Watts output. (I've no idea ...
Read more